## Once your ZEN55 DC Signal Sensor is properly powered and installed, it's time to include the device to Home Assistant. Inclusion is a simple process; just follow the steps below to have your device added to your Home Assistant in no time. ## We recommend using the new [JS Z-Wave integration][1] for optimal results…
## The ZEN55 DC Signal Sensor is compatible with the following Z-Wave systems: * [Z-Box Hub][1] **(recommended for Zooz products)** * Home Assistant (Z-Wave JS) * Hubitat ([custom driver required][2]) * SmartThings ([Edge driver needed][3]) **_Will the device work with my alarm panel?_** * No. * Alarm …
## Use the custom driver below to ensure you can access the advanced settings and complete set up of your ZEN55 DC Signal Sensor. Start by ensuring your hub is operating on the latest Hubitat platform version before installing the driver. Then follow these step-by-step instructions to install the custom driver for th…
## With SmartThings transitioning to a new platform (the [lua platform][1]), the old Groovy custom device handlers will now be unusable. But we've created a new custom Edge driver for the ZEN55 DC Signal Sensor for the lua platform! Below are the instructions on how to install and if you haven't added one before, it'…
**Here are the technical details and specs for the ZEN55 DC Signal Sensor:** * Z-Wave Frequency: 908.42 MHz (US) * Power: 120-240 VAC, 50/60 Hz * Maximum Loads: 10 A * Z-Wave Range: Up to 300 feet line of sight (or up to a mile with Long Range enabled) * Dimensions: 1.5" tall, 1.4" wide, 0.7" deep * Opera…
## The ZEN55 DC Signal Sensor is a unique Z-Wave device that can read analog signals from interconnected smoke and CO alarms as well as control a connected 120 V load. Please remember that the DC Signal Sensor is NOT a security alarm component and the device is NOT part of a life-safety system. Check local regulations…
## Here is a full list of advanced settings (parameters) for the ZEN55 DC Signal Sensor: ### _LED Indicator_ **Parameter 1: **Enable or disable the LED indicator to reflect the current on/off status of the connected load (LED on when the load is on, LED off when the load is off). **Values: ** 0 – LED Indicator dis…
Here is a list of the changes and updates we made to the ZEN55 DC Signal Sensor so far. ### _VER. 1.0 (released 4/2023)_ _Original release._ **Hardware:** * 800 Series Z-Wave chip * Pigtail wires for easy installation **Firmware: 1.20** * Separate reports for smoke and CO alerts * Z-Wave Long Range read…
SmartThings is slowly transitioning from the legacy groovy platform to the [new lua platform][1]. This creates new challenges for seamless integration as well as access to key and advanced features of our devices. As usual, we're committed to providing the best possible experience to all of our customers, regardless o…