ZEN73 On/Off Toggle Switch Change Log
Here are the changed and updates we made to the ZEN73 On/Off Toggle Switch 700 so far.
VER. 1.0 (released 4/2021)
Original release.
Hardware:
- Implemented simple direct 3-way solution (wires like the ZEN76 model and NOT like the old ZEN23 model in 3-way and 4-way set-ups)
- 700 Series Z-Wave chip
- Just 1.16" deep
- No heatsink tabs
Firmware: 1.02
-
SmartStart and S2 authenticated security
-
Built-in signal repeater
-
Smart bulb mode
-
Scene control command class (multi-tap triggers)
VER. 10.0 (released 7/2021)
Firmware: 10.0
- Removed manual operation delay with scene control disabled
- Fixed smart bulb behavior after a power outage: the actual status of the relay and the reported status of the relay are both restored correctly now
- Added the ability to disable programming function from the paddles (parameter 17, see all of the settings here)
VER. 800LR (released 12/2023)
Hardware: 2.0
- 800 Series Z-Wave chip
Firmware: 2.10
- Long Range ready
- Fixed central scene bug for control of its own load in smart bulb mode
- Added parameter 18 to disable LED blinking when a setting is changed. See all settings here.
- Changed the manual operation for disabling the relay (smart bulb mode): Hold the UPPER paddle for 10 seconds until the LED indicator starts blinking, then within 2 seconds, tap the upper paddle 5 times quickly to change this mode. The LED indicator will stay solid green for 3 seconds to confirm the change.
- Improved the factory reset procedure: The switch will not lock up if the factory reset is not successful in certain scenarios.
Firmware: 2.20 (released 09/2024 as OTA)
- Fixed the Range Test Tool feature
Firmware: 2.30 (released 02/2025 as OTA)
- Updated parameter names and short descriptions in the Configuration Command Class to match the Advanced Setting Article.
