Troubles adding your ZEN52 to HomeSeer? You may need to try exclusion first. This process can be done with any Z-Wave device, on any Z-Wave hub, at any time, regardless of the device's inclusion status

The exclusion process simply acts as a soft reset and can be done even if you haven't paired the ZEN52 to HomeSeer or another Z-Wave network before.

Zooz products are officially integrated with the Z-Wave Plus and the Z-Wave JS Front-End of HomeSeer. If you're experiencing issues with accessing the advanced settings of your device or the unit not properly displaying, we would recommend first updating to the Z-Wave Plus or the Z-Wave JS Front-End, then excluding and re-including your device to your network in order for it to be recognized correctly.

Important Note: A steady, blinking green is the standard state for the device; as long as the unit has power, it will blink green at a steady pace. The device has an internal relay, which can turn on and off with a click of the Z-Wave button. This means that when you are attempting to include or exclude the device, the clicks need to happen as fast as possible; if the clicks are not completed fast enough, the relay will engage instead and the device will not enter inclusion or exclusion mode. You will know you have clicked fast enough when the LED indicator begins flashing rapidly.

ZEN52 Exclusion Steps

1. In the HomeSeer UI, click Plugins > from the drop-down menu, select Z-Wave.

2. Select Remove Device.

3. You will be taken to a new page; click Continue to start the exclusion process on the hub.

4. Click the Z-Wave button 3 times very quickly (the LED indicator will start flashing rapidly). Alternatively, if the relay is already installed, you can simply toggle the external switch connected to ZEN52 very quickly from off to on, so: "up-down, up-down, up-down." Check out the video linked here to show you how this process works!

5. HomeSeer should confirm the device was removed. Finalize by clicking Finish.

Once the exclusion process is successfully finalized, try including the device to HomeSeer. 

SmartStart and Z-Wave Long Range Inclusion Troubleshooting

If exclusion is not successful, if you have previously added this device to your hub, if SmartStart failed, or if the device will not include, please follow the steps below in order. Removing the device from the provisioning list generally resolves most inclusion issues:

1. Click Plugins > Z-Wave Plus > Z-Wave JS Front-End.

2. Click the SmartStart icon.

3. Locate your device via the DSK number and click the trash icon to remove it from the provisioning list:

The device has now been removed from the provisioning list.

  4. Factory reset on the ZEN52. After a successful reset, the device will disappear from the device list.

  5. Remove the ZEN52 from power if you plan to include the unit via SmartStart / Z-Wave Long Range. 

  6. Go through the inclusion steps listed here to include the device (remember, power stays OFF until indicated).

Additional Troubleshooting

• Try the exclusion process again in case the command from the first run weren't registered correctly. 

• Try bringing the hub closer to the device to see if it connects in a closer location. If it connects without issue in the new spot, then the first location may be out of range or there may be too many interferences in that area.

• And if you find that your device is connected but it's not responded to remote commands, check out these tips for troubleshooting connectivity. 

If you've tried all the above with no luck, let us know! Our team is ready to help.