Here is a full list of advanced settings (parameters) for the ZSE41 XS Open | Close Sensor:
LED Indicator
Parameter 1: Decide if you want the LED indicator to blink when open/close status changes.
Values: 0 – LED doesn't blink on status change; 1 – LED blinks on status change. Default: 1.
Size: 1 byte dec
Battery Reporting Threshold
Parameter 3: Set the threshold for battery reporting in % changes.
Values: 1-50 (%). Default: 10.
Size: 1 byte dec
Low Battery Report
Parameter 4: Decide when the sensor should report low battery to the hub.
Values: 10-50 (% battery life). Default: 20.
Size: 1 byte dec
Status Reporting
Parameter 5: Decide which status should the sensor report to the hub when the magnet touches the sensor.
Values: 0 – closed status reported when the magnet is by the sensor; 1 – open status reported when the magnet is by the sensor. Default: 0.
Size: 1 byte dec
ON Basic Set Reporting Delay to Group 2
Parameter 6: Set the delay for the ON basic set command to be sent to the devices associated in Group 2 after the door is open.
Values: 0-3600 (seconds). Default: 0 (no delay).
Size: 4 byte dec
OFF Basic Set Reporting Delay to Group 2
Parameter 7: Set the delay for the OFF basic set command to be sent to the devices associated in Group 2 after the door is closed.
Values: 0-3600 (seconds). Default: 0 (no delay).
Size: 4 byte dec
How to Access the Advanced Settings
How to Access the Advanced Settings for the ZSE41 on Home Assistant
How to Access the Advanced Settings for the ZSE41 on HomeSeer
How to Access the Advanced Settings for the ZSE41 on Hubitat
How to Access the Advanced Settings for the ZSE41 on SmartThings
How to Access the Advanced Settings for the ZSE41 on Z-Box
Supported Command Classes
- Z-Wave Plus Info V2
- Security 2 V2
- Supervision V1
- Transport Service V2
- Association V2
- Multi Channel Association V3
- Association Group Information V3
- Configuration V4
- Version V3
- Manufacturer Specific V2
- Device Reset Locally V1
- Power Level V1
- Firmware Update Meta Data V5
- Battery V1
- Indicator V3
- Notification V8
- Wake Up V2
Manual Wake-Up
Remember to click the Z-Wave button 4 times quickly to wake the sensor up after updating the settings.
Your Open | Close Sensor can be updated via OTA firmware updates. You can access all firmware files here. Questions? Just reach out to our tech support team.