ZEN34 Remote Switch Manual Wake-Up Process

Looking for Z-Box Hub Support? Please click here to access the Z-Box Hub Support Portal.

Home > Scene Controllers & Remotes > ZEN34 Remote Switch > ZEN34 Remote Switch Manual Wake-Up Process

So you made a change to the advanced settings, but they haven't taken effect or your hub shows a pending change? You may need to wake your Remote manually!

All battery powered devices are normally sleeping, to conserve battery.

You will need to wake the Remote Switch up after changing any advanced settings or assigning any new scenes or actions to it.

To manually wake the ZEN34:

Click the upper paddle 7 times as quickly as possible to wake the device up.
The LED indicator will stay on solid blue during the wake-up and will turn off when the device turns the Z-Wave radio off again.

Please don't hesitate to reach out to us with any questions!

Feedback

1 out of 1 found this helpful

Need additional information

Hard to understand

Inaccurate/irrelevant content

Missing/broken link

Have you tried our virtual assistant chatbot? This AI tool can help you find answers from thousands of articles in our Knowledge Base quickly. Find it in the bottom righthand corner of the page.

Need more help? Our friendly team is ready to help you with any questions or concerns you may have about Zooz devices. Click here to submit a support ticket.

Are your devices registered? Extended warranty and firmware access is available for registered Zooz customers. Click here to submit your registration form.

Find the latest Zooz devices and great Z-Wave deals at The Smartest House.