So you made a change to the advanced settings, but they haven't taken effect or your hub shows a pending change? You may need to wake your sensor manually!

Battery powered devices are normally sleeping, to conserve battery. If you've made a change to the advanced settings for the ZSE11, the change will take effect once the device wakes up to receive communication from the hub. The sensor’s wake-up interval is set to 4 hours by default to save battery life.

You can also manually wake the sensor to receive any communication from the hub and have parameter changes take effect immediately:

• Press and hold the ZWave button for 3 seconds to wake the sensor up manually. During wake-up, the sensor turns the Z-Wave radio for a couple of seconds to receive communication from the hub. Long wake-up interval will not affect how often the sensor reports motion or other values to your hub.

Please don't hesitate to reach out to us with any questions!