You are using an unsupported browser. Please update your browser to the latest version on or before July 31, 2020.
close
You are viewing the article in preview mode. It is not live at the moment.
Looking for Z-Box Hub Support? Please click here to access the Z-Box Hub Support Portal.
Home > Security Sensors & Sirens > ZEN55 DC Signal Sensor > ZEN55 & Hubitat > How to Add Your ZEN55 DC Signal Sensor to Hubitat
How to Add Your ZEN55 DC Signal Sensor to Hubitat
print icon

So your new ZEN55 DC Signal Sensor is properly installed and ready to go? Let's get it included to your Hubitat hub. Including the ZEN55 DC Signal Sensor to Hubitat is simple! Follow the steps below to quickly and easily add the ZEN55 to Hubitat. 

Please install the ZEN55 custom driver to have complete configuration before pairing: Driver installation found here.

 

Here are the steps for including the ZEN55 DC Signal Sensor to Hubitat:

 

Smart Start Inclusion

On the Hubitat app:

  1. Open the Tools tab (wrench icon on the bottom)
  2. Scroll to the bottom, select Z-Wave
  3. This will take you to a screen where you can select either Smart Start or regular inclusion
  4. Select Smart Start
  5. This will take you to the smart start inclusion list. Devices will be displayed there that are in the process of inclusion through Smart Start.
  6. Select the QR symbol in the top right to open the camera for the DSK scan; scan the QR code printed on the relay.
  7. Power the device (important to do this AFTER QR scan)
  8. The device integration will begin. The window will appear asking you to name the device; click Save after naming
  9. Finishing inclusion may take a few minutes 

If you have any issues with Smart Start Inclusion on Hubitat, please review this video: https://www.youtube.com/watch?v=Sf-Fldjb0to. The steps should be the same whether you have a C-7 or C-8.

 

Manual Inclusion

  1. Open Hubitat in your Internet browser

  2. Go to Devices

  3. Click on + Add Device in the top right corner

  4. Click on Z-Wave

  5. Click on Start Z-Wave Inclusion

  6. While the app says it is in inclusion mode, click the Z-Wave button on the ZEN55 3 times as quickly as possible (the LED indicator will start flashing)

  7. If you're using a hub that supports S2 security, it may ask you to enter the PIN. The PIN is located on the back of the device, next to the smart start QR code.

  8. Rename and confirm the found device

Problems connecting? Give exclusion a try first! It will help the ZEN55 DC Signal Sensor to configure properly, even if it has never been connected to the hub:

  1. Open Hubitat in your Internet browser

  2. Go to Devices

  3. Click on + Add Device in the top right corner

  4. Click on Z-Wave

  5. Click on Start Z-Wave Exclusion

  6. While the device is searching for a device, click the Z-Wave button on the device 3 times as quickly as possible

  7. The app will indicate when the device is successfully excluded.

Still having issues including your device? Please reach out to us with any questions you may have!

Feedback
0 out of 0 found this helpful

Have you tried our virtual assistant chatbot? This AI tool can help you find answers from thousands of articles in our Knowledge Base quickly. Find it in the bottom righthand corner of the page.

Need more help? Our friendly team is ready to help you with any questions or concerns you may have about Zooz devices. Click here to submit a support ticket.

Are your devices registered? Extended warranty and firmware access is available for registered Zooz customers. Click here to submit your registration form.

Find the latest Zooz devices and great Z-Wave deals at The Smartest House.
 
scroll to top icon