ZEN05 Outdoor Smart Plug Change Log
Here is a list of updates we made to the ZEN05 model so far:
VER. 1.0 (released 7/2022)
Original release.
Hardware:
- Weather-resistant housing (IP65)
- Angled plug to free up the second outlet
- 700 Series Z-Wave chip for extra range and reliable communication
Firmware: 1.10
- Quick on/off wireless control with instant status reports
- Remembers and restores status after power failure
- SmartStart and S2 authenticated security
VER. 800LR (released 03/2024)
Hardware: 2.0
- 800 Series Z-Wave chip
- Energy monitoring, overload protection
Firmware: 2.0
-
Added new advanced parameters for Power Wattage, Electrical Current, Energy, and Voltage monitoring (Frequency, Threshold, Enable/Disable). See all advanced settings here.
Firmware: 2.10 (released 04/2025)
- Updated parameter names and short descriptions in the Configuration Command Class for improved clarity and consistency.
- Updated parameters 9, 11, and 12 to extend the W, A, and kWh threshold range. See all settings here.
- Added the ability for parameters 9, 11, and 12 to disable reporting based on threshold and report based on frequency for W, A, and kWh. See all settings here.
- Added new parameters 17 (kWh Report Frequency) and 18 (Disable kWh Reports). See all settings here.
Firmware: 2.20 (released 07/2025)
- Optimized Z-Wave reporting behavior: when Basic Set or Binary Set commands are sent from the Z-Wave controller (Lifeline), the device will no longer send redundant report or notification commands back to the controller.
- Adjusted the over-voltage protection threshold in the firmware from 135VAC to 150VAC to minimize false triggers in specific scenarios.
Your ZEN05 Plug can be updated via OTA firmware updates. You can access all firmware files here after you register your product and create an account here. Questions? Just reach out to our tech support team.
