You'll want a strong mesh to ensure you get the best performance from your ZSE42 Water Leak Sensor!
To power the sensor, you'll want to use the included CR2032 battery.
New battery and the device is not responsive? Please try the steps below:
- Make sure the batteries are properly oriented
- The sensor will not work if the batteries are inserted incorrectly
- Exclude and reinclude the ZSE42
- Bring the ZSE42 close to your hub during the process to prevent any range or interference issues. Run a network repair, if supported by your hub, once the ZSE42 is fully set-up and installed in its target location.
Connectivity Trouble? The strongest Z-Wave networks have various signal repeating devices installed to allow for a stronger mesh and better connection and communication. The ZSE42 sensor has a Z-Wave range of up to 300 feet line of sight, but obstacles like thick walls, large furniture, and glass or metal elements can limit the Z-Wave signal. Try adding a Z-Wave signal repeater between your hub and the sensor if its installation location is far from the hub.
All non-battery powered Z-Wave devices act as signal repeaters. Install them in areas where there aren't many signal repeating Z-Wave devices, to allow the hub to form solid communication routes to all the devices in your network. The repeater can be any smart plug or switch, like the ZEN25 Double Plug or ZEN15 Power Switch, or a dedicated Z-Wave signal repeater, like this one here.
Repeaters may not be necessary if you have a large network of Z-Wave devices. If the hub is having difficulty communicating with the sensor, then you may need to try a different location within the hub's range, adding a repeater, or relocating an existing repeater in your house to help with any range or communication issues. If your ZSE42 is within range and in an area with other signal extenders, and still having problems, then these other hub-specific troubleshoots could be worth trying.
Connect the Water Leak Sensor to other Z-Wave devices for advanced automation scenarios: trigger your smart water valve actuator to immediately shut off flow when a leak is detected. Pair it with an alarm siren located on the main floor to ensure a fast response.
Check out the ZAC36 Titan Water Valve Actuator to use with the ZSE42! Also available in the Basic and Pro kits with the ZSE42 included. The Titan will fit on valves up to 1.25". Is your pipe larger? Reach out to us about an extension kit for the ZAC36 to accommodate larger pipes/valves.
Zooz Z-Wave Plus Flood Prevention Kit: Basic (ZAC36 + 1 ZSE42 Sensor)
Zooz Z-Wave Plus Flood Prevention Kit: Pro (ZAC36 + 2 ZSE42 Sensors)
Have any questions about your ZSE42? Send us a message!
