Ready to add the ZEN77 Dimmer to Hubitat? Let's get started!
Here are the steps for getting your S2 800 Dimmer paired with your Hubitat network:
Smart Start Inclusion
On the Hubitat app:
- Open the Tools tab (wrench icon on the bottom)
- Scroll to the bottom, select Z-Wave
- This will take you to a screen where you can select either Smart Start or regular inclusion
- Select Smart Start
- This will take you to the smart start inclusion list. Devices will be displayed there that are in the process of inclusion through Smart Start.
- Select the QR symbol in the top right to open the camera for the DSK scan
- Power the device (important to do this AFTER QR scan)
- The device integration will begin. The window will appear asking you to name the device; click Save after naming
- Finishing inclusion may take a few minutes
If you have any issues with Smart Start Inclusion on Hubitat, please review this video: https://www.youtube.com/watch?v=Sf-Fldjb0to. The steps should be the same whether you have a C-7 or C-8.
Manual Inclusion
-
Open Hubitat in your Internet browser
-
Go to Devices
-
Click on Discover Devices in the top right corner
-
Click on Z-Wave
-
Click on Start Z-Wave Inclusion
-
While the app says is in inclusion mode, tap the upper paddle of the dimmer 3 times as quickly as possible.
-
The LED indicator will blink blue to show signal communication, turn green for 3 seconds once inclusion is successful, or red for 3 seconds if inclusion fails.
-
-
Rename and confirm the found device
Don't hesitate to contact us if your switch is not pairing, or if you have any other questions!
