You are using an unsupported browser. Please update your browser to the latest version on or before July 31, 2020.
close
You are viewing the article in preview mode. It is not live at the moment.
Looking for Z-Box Hub Support? Please click here to access the Z-Box Hub Support Portal.
Home > Smart Relays > ZEN53 DC Motor Controller > How to Calibrate Your ZEN53 DC Motor Controller
How to Calibrate Your ZEN53 DC Motor Controller
print icon

How to Calibrate Your ZEN53 DC Motor Controller

 

1. Automatic Calibration

 

Use this method for motors with limit switches.

 

  •  Click the Z-Wave button 6 times quickly to enter calibration mode (or set parameter 5 to value 1 for shutter mode or value 2 for Venetian mode, add to hub first).
  •  The device will start calibrating while blinking green. The process takes around 10 seconds.
  •  The motor will start opening the blinds until it reaches the limit and the blind is fully open. It will then reverse operation and start closing the blind until it reaches the closed limit.
  •  The calibration process is now complete. The device has calculated the total time it needs to fully open or close your blinds or shutters. It will use this data to execute open and close commands. If you need to make any adjustments manually, you can enter the new values in parameters 3 and 4 in the advanced settings.

 

2. Manual Calibration

 

Manually triggering the automatic calibration for the specific curtains with rails with no end-limits via the Z-Wave button.

 

  • To manually trigger the automatic calibration of the rail curtains please click the Z-Wave button on ZEN53 six times quickly.
  • The rail curtain motor will be running for automatic calibration
  • When the motor runs to one end of the rail, it will detect a stop and will run in the opposite direction
  • The motor now runs to the other end of the rail and detects another stop. The motor will stop.
  • Calibration is now finished.

 

NOTE: The automatic calibration is only applicable for motor curtains with rails, which can fail to stop the motor when it runs to the end. Please always check if your curtains motor needs calibration, or if already have ends limits built-in.

 

Questions or concerns? Please reach out to us!

Feedback
0 out of 0 found this helpful

Have you tried our virtual assistant chatbot? This AI tool can help you find answers from thousands of articles in our Knowledge Base quickly. Find it in the bottom righthand corner of the page.

Need more help? Our friendly team is ready to help you with any questions or concerns you may have about Zooz devices. Click here to submit a support ticket.

Are your devices registered? Extended warranty and firmware access is available for registered Zooz customers. Click here to submit your registration form.

Find the latest Zooz devices and great Z-Wave deals at The Smartest House.
 
scroll to top icon