Looking for the ZSE43 advanced settings? Hubitat should fully recognize your Tilt | Shock sensor out of the box!
First, confirm your Hubitat hub is on the latest platform version, and that your ZSE43 has the most recent firmware update. Once you have verified this, add the ZSE43 again and you'll be able to see the advanced settings under Preferences of the primary device in Hubitat (remember to save the device after each change).
If you'd like to adjust a setting that isn't exposed in the built-in driver, you can try using the custom driver below:
Here are the steps for installing the custom driver:
- Open Hubitat in your browser
- Click on Drivers Code in the side menu
- In the top right corner, click on "+New Driver" and paste the code from the following link
-
to access the code for the driver, then copy ALL of the code from the page.
-
Click Save in the top right corner.
-
You'll see a Zooz ZSE43 Tilt-Shock XS Sensor in your Drivers Code list now.
-
Assign the driver to the device by opening to the device view and selecting the Zooz ZSE43 Tilt-Shock XS Sensor from the drop-down menu under Device Type.
-
Click Update Device.
-
You will now see the additional setting display in the device view in Hubitat where you can customize the sensor.
-
Once done, click Update Device again.
Let us know if you have any questions!