ZSE70 Outdoor Motion Sensor Change Log
Here are the changes we made to the ZSE70 model so far.
VER. 1.0 (released 6/2024)
Original release.
Hardware: 1
- Battery or 12-24 V power with sealed terminals
- Rated for indoor or outdoor use
Firmware: 1.20
-
800 series Z-Wave chip
-
S2 Authenticated security
-
Motion, temp, and lux reporting
-
Z-Wave Long Range for no-mesh communication
Firmware: 1.30 (released 04/2026 as OTA)
-
Fixed a bug that caused the sensor to report negative lux values under certain conditions on specific platforms.
-
Fixed a bug where setting parameter 16 to any value other than the default prevented the LED indicator from flashing on motion.
- Updated parameter names and short descriptions in the Configuration Command Class for improved clarity and consistency.
- Updated SDK from 7.19.3 to 7.24.2
- Added Long Range support for Europe
Firmware: 1.40 (released 08/2026 as OTA)
- Fixed a bug introduced in firmware 1.30 where waking up to measure temperature or ambient light could incorrectly trigger a change in the PIR motion status. The PIR status now remains unaffected during scheduled sensor measurements.
- Fixed a bug in S2 Authenticated Security where direct association commands could fail due to duplicate Supervision session IDs (SDK 7.24.2 issue), preventing the associated device from turning off after motion was cleared.
