While the ZSE44 XS Sensors will pair with your hub without additional setup on Hubitat, we recommend using the custom driver with this model as of May 2022. Follow the instructions below to install the driver before you include your sensor to Hubitat.
First, install the custom driver:
-
Open Hubitat in your browser.
-
Click on Drivers Code in the side menu.
-
In the top right corner, click on "+New Driver" and paste the code from this link to access the code for the driver, then copy ALL of the code from the page.
-
Click Save in the top right corner.
-
You'll see a Zooz ZSE44 Temperature Humidity XS Sensor in your Drivers Code list now.
Now include the ZSE44 sensor to Hubitat:
Smart Start Inclusion
On the Hubitat app:
- Open the Tools tab (wrench icon on the bottom)
- Scroll to the bottom, select Z-Wave
- This will take you to a screen where you can select either Smart Start or regular inclusion
- Select Smart Start
- This will take you to the smart start inclusion list. Devices will be displayed there that are in the process of inclusion through Smart Start.
- Select the QR symbol in the top right to open the camera for the DSK scan; scan the QR code printed on the inside of the sensor battery cover.
- Power the device (important to do this AFTER QR scan)
- The device integration will begin. The window will appear asking you to name the device; click Save after naming
- Finishing inclusion may take a few minutes
If you have any issues with Smart Start Inclusion on Hubitat, please review this video: https://www.youtube.com/watch?v=Sf-Fldjb0to. The steps should be the same whether you have a C-7 or C-8.
Manual Inclusion
-
Power the sensor up.
-
Open Hubitat in your Internet browser
-
Go to Devices
-
Click on + Add Device in the top right corner
-
Click on Z-Wave
-
Click on Start Z-Wave Inclusion
-
While the app is in inclusion mode, click the Z-Wave button on the sensor 3 times as quickly as possible (the LED indicator will start flashing)
-
If you're using a hub that supports S2 security, it may ask you to enter the PIN. The PIN is found under the QR code printed on the inside of the battery cover of your sensor
-
Rename and confirm the found device
If the sensor is having issues connecting to Hubitat, begin the exclusion process. This will help the ZSE44 Sensor to configure properly, even if it never connected to the hub:
-
Open Hubitat in your Internet browser
-
Go to Devices
-
Click on + Add Device in the top right corner
-
Click on Z-Wave
-
Click on Start Z-Wave Exclusion
-
While the device is searching for a device, click the Z-Wave button on the sensor 3 times as quickly as possible
-
The app will indicate when the device is successfully excluded.
Please let us know if you’re having difficulties adding the sensor to your network, we’ll help!