Use the custom driver below to ensure you can access the advanced settings and complete set up of your ZEN55 DC Signal Sensor.
Start by ensuring your hub is operating on the latest Hubitat platform version before installing the driver. Then follow these step-by-step instructions to install the custom driver for the ZEN55:
-
Open Hubitat in your browser.
-
Click on Drivers Code in the side menu.
-
In the top right corner, click on "+New Driver" and paste the code from the following link to access the code for the driver, then copy ALL of the code from the page.
-
Click Save in the top right corner.
-
You'll see a Zooz ZEN55 Double Relay Advanced in your Drivers Code list now.
-
Assign the driver to the device by opening to the device view and selecting the Zooz ZEN55 DC Signal Sensor Advanced from the drop-down menu under Device Type > User.
-
IMPORTANT: Click the Configure button and refresh the page in your browser for all of the settings to display.
-
Adjust all of the settings as needed.
-
Click Update Device.
If you need any additional assistance with your ZEN55, please don't hesitate to reach out to us!
